KY - Packings

Sakagami Hydraulic Seals
KY-Packings

KY-Packings ** PLEASE DESCRIBE THIS IMAGE **
Hydraulics
Packings used for both piston and rod.
Install in the one piece groove

** PLEASE DESCRIBE THIS IMAGE **

1) Packings have a directional nature as in the above drawing. Be careful of the direction when installing.
2) Diameter D H9/f8 is changed by the bearing application


** PLEASE DESCRIBE THIS IMAGE **

1) Use divided grooves in regards to KY-Packings. It is possible to install packings of more than D=140mm for pistons and more than d=80mm for rods into the one piece grooves. In this case, designate the bias cut (TC-KY) as Back-up Rings.



1) Orders and inquiries are accepted by part numbers.
2) Products of the listed part number printed on colored grounds are in stock.
3) Products in thin italics should be ordered after checking the existence of the tooling. If the tooling has been scrapped, the tooling charges are at your expense.
4) Packings are packaged to be suitable for storage.
5) See "Caution notice" regarding the method of handling and stocking.

Service Range

  KY-Packings KY-Packings with
Back-up Rings
KY-Packings with Back-up Rings plus
high pressure Back-up Rings
max. pressure 15MPa(175kgf/cm²) 30MPa(300kgf/cm²) 35MPa(350kgf/cm²)
temperature RN906 : -10 to 80°C (RF905 : -5 to 150°C)
Powered by VE Media